MODEL TP-20 20,000-LB. LIFT

Solid, SAFE & CERTIFIED.
 
US PATENT #4500071 CANADIAN PATENT #436053


The lift for ALL your fleet

7"wide by 1" thick High strength fork lift
channel construction
 

Mohawk large and stable footprint measures 48" wide x 30" deep and is made of 1" thick plate. Mohawk's large base gives stability to the lift, while distributing the load to the shop floor. The TP-20 only requires 61/2" of concrete.

Mohawk's all position mechanical and hydraulic safety systems lock the vehicles at ALL working heights. Mohawk safeties consist of 11/2" plate steel locks engaging into the slotted carriage lock racks every 6" inches.

3 HP single or 3 phase electric/ hydraulic power unit delivers fluid to large twin hydraulic cylinders. Optional 3 phase 5HP motor speeds the lifting cycle to 90 seconds.
 

Mohawk's TP-20 gives FULL under vehicle access for all repairs, takes up minimal bay space, while leaving the wheels hanging free for tire, brake or any other necessary repairs.

Mohawk TP-20 columns are constructed of 1" thick, high strength fork lift mast channels, using 24 double sealed, self lubricating ball bearing rollers to smoothly raise the lift, using large 41/2" cylinders for a lifetime of trouble free service.

Mohawk double telescoping 3 stage swing arms are only 5 3/8" high to fit under the passenger cars in your fleet. Triple telescoping arms allows lifting of vehicles from large utility trucks, down to short wheelbase sub-compact cars.

Mohawk TP-20 design

  • Lifts vehicles up to 20,000 lbs.
  • Surface mounted design bolts to the shop floor.
  • No in-ground oil tanks, no digging for installations, making installations fast and service easy.
  • Low profile, 3 stage arms for access under compact cars through medium duty trucks.
  • ALI safety certified to meet national and local OSHA & ANSI codes (ANSI/ALI ALCTV-1998) for the safety of your shop's employees.
  • Light thru medium duty vehicles, Mohawk's TP-20 lifts them all.

Features

  • Constructed of heavy 7" x 1" fork lift mast channels (NOT formed sheet metal)
  • Each of the carriages ride on double sealed, self lubricating ball bearing rollers (NOT plastic slide blocks) for a lifetime of maintenance free service.
  • Direct drive lifting rods attached to each cylinder and carriage (no cables, chains, or pulleys) means no parts to wear or maintain
  • WIDE 48" base for stability.

Benefits

  • 3 section swing arms make positioning easier than a 2 stage arm and increases lifting range, for all wheelbases.
  • 5", 7 1/2" and 10" stacking truck adaptors included to reach truck frames and get around fuel tanks or tool boxes.
  • Built Mohawk TOUGH-the TP-20 is the virtually the same structural column and same carriage used in Mohawk's TP-26 and TP-30!
  • Built to last forever.

Safeties

  • Single position mechanical lock release, located at the main post, unlocks both safeties.
  • Release the mechanical locks with Mohawk's air cylinders. Upon release, safeties immediately re-engage.
  • 20,000 lb. capacity to safely raise fully loaded work and utility trucks.
  • 12 position 11/2" steel plate safety locks in each post start engaging at 5" and continue every 6" through the full lifting height.


Mobile Column
Lifts