The Challenger CL10V3-QC is an industry first two post lift with standard Versymmetric® offset 3-stage front + 3-stage rear arms. This arm configuration provides maximum arm sweep, retration and reach , and single sweep spotting of virtually any vehicle.
Other CL10series two post lift features include double telescoping screw pads, Heavy-Duty pulley and cable equalization system, elongated carriage, fully gusseted base plate design, single point
mechanical lock release and padded overhead shut off system.
Service more vehicles and make more money with CL10series automotive lifts. Versymmetric® Technology facilitates increased efficiency and revenue by providing the versatility to safely lift vehicles symmetrically or asymetrically within the same service bay.
|Lifting Capacity*||10,000 lbs.|
|A: Rise Height(1)||75-1/8"|
|B: Column Height||140"|
|C: Cylinder Overall(Full Stroke)||143"|
|D: Adjustable Width Overall||138-1/2" / 143"|
|E: Drive-Thru Clearance(2)||100" / 104-1/2"|
|F: Floor to Overhead Switch(2)||134-1/2"|
|G: Front Arm Reach(Min/Max)||Min. 19-13/16" / Max. 42"|
|H: Rear Arm Reach(Min/Max)||Min. 37-5/8" / Max. 60"|
|I: Screw Pad Height(3)||Min. 3-7/8" / Max. 6-1/8"|
|J: Inside Columns(4)||110" / 114-1/2"|
|Ceiling Height Required||144"|
|Motor||3HP, Single Phase, 60Hz|
|Speed of Rise||27 Sec. (approximate)|
|Max. Load Per Arm||2,500 lb.|
|*Lift capacity ratings are based on loads equally distributed on all four arms.|
|1 Rise height is measured with adjustable screw pads in highest position.|
|2 Specifications are listed with lift at maximum width and/or height settings.|
|3 Specifications are listed without rubber pad, for measurements with rubber pad add 1/4".|
|4 Optional 3 phase electrical also available, please specify at time of order. Optional frame engaging adapters (10314 or 10318) are REQUIRED when lifting vehicles with frame construction. Standard lift colors are Red and Blue. Optional colors available.|